Your shopping cart is empty!
| MODEL | KTR-40L |
| chamber (inner dia x depth) | φ400X300m |
| usable capacity | 105 |
| usable max. press. | 0.16Mpa |
| usable max. temp. | 125°C |
| sterilization | 110 - 125°C |
| system | saturated steam generated by sheathed electric heater |
| main controlller | digital temperatur/time controller |
| Timer | 0 - 60min. 59sec. (operates after the set tempeature is reached.) |
| Operation start | PUSH-ON start button switch |
| Air exhaust valve | gravity substitution sistem by temperatur sensing time controlled solenoide valve |
| water lack peventor | outomatic out-off system by a sesitive thermostat and relay (healer cut off, buzzer & red lamp warning) |
| exhaust valve | manual needle valve to be opened only in rapid exhaust required |
| drain valve | manual ball valve (inner dia: 10mm) |
| sterilization pattern | (temperature/time set) PUSH-ON start-Sterilization Natural cooling |
| - Completion buzzer- RUN lamp off at safe temp. for lid open(80°C) | |
| Operation Pattern with drying | (Sterilization/Drying temperature/time set) PUSH-ON start-Sterilization Natural cooling |
| → Completion buzzer-STER lamp off at safe temp.(80C) Switching from STER, to DRY and DRAIN valve knob to open | |
| PUSH-ON start Automatic drain of hot bottom water Drying Natural cooling | |
| → Completion buzzer DRY lamp off at safe temp, for lid open(80°C) | |
| drying devices | Hot air circulating and discharge by heaters around chamber and air pump through bore dia 0.2μm capsule filter |
| Drying temperature: 130C (100-150°C available). Timer: 0-99hr. 59min. | |
| safety device | Water lack preventor. Over pressure safety switch, Saftey valve Breaker for over current & earth leakage |
| electric safety | Breaker for over current & earth leakage |
| Withstand valtage: 1.400V, 2sec. Insulation: 100MC-(500V.D.C) | |
| safety valve operasion | 0.18MPa |
| water test pressure | 0,36MPa |
| presssure vassel standard | [Summary & Small pressure vessel) in Japanese law |
| chamber & lid | Stainless steel SUS304 shiny polished. Lid gasket: Molded silicone rubber |
| outer panel | Upper surface: SUS304, Main body: Steel with baked enamel, Caster(front two with stopper) |
| power requirement | AC 220/230/240V, 1phase, 50/60Hz |
| 3.6kW 18A) | |
| outer seze WXDXH | 770x550x1140 |
| weight | 86/95kg |
| stainless wire basket | $380x400mm |
| (except Ktr-DP models) | 2pcs |
| bottle & hose | Exhaust drain receiver bottle, Stainless drain hose |
| KTR-DP Models | Stainless drain hose (Stainless wire basket: option) |
